Tuesday, 1 October 2013

MTS Data Card Installation in ubuntu 12.04


For configuring the MTS Mblaze Datacard on ubuntu, Please do the following steps.

1)First install the service wvdial.

sudo apt-get install wvdial

2) Then create a configuration file /etc/wvdial.conf and add the following configurations on it.

[Dialer mts]
Stupid Mode = 1 
Inherits = Modem0 
Password = mts 
Username = 
Phone = #777 
Init1 = ATZ 
SetVolume = 0 
Modem = /dev/ttyUSB0 
Baud = 115200 
FlowControl = Hardware (CRTSCTS) 
Dial Command = ATDT 
3) After this just plugin the the MTS data card on the ubuntu machine. The data card will be automatically detected on the ubuntu machine.

After this run the following command

  sudo wvdial mts

 --> WvDial: Internet dialer version 1.61
--> Initializing modem.
--> Sending: ATZ
--> Modem initialized.
--> Sending: ATDT#777
--> Waiting for carrier.
CONNECT 3100000
--> Carrier detected.  Starting PPP immediately.
--> Starting pppd at Tue Oct  1 21:21:48 2013
--> Pid of pppd: 8718
--> Using interface ppp0
--> local  IP address
--> remote IP address
--> primary   DNS address
--> secondary DNS address

Now you will be able to connect to the machine.

Also you can configure it on the Network Manager. For this do the following steps.

1)Click on the Connections Tab on the right side of your desktop.
2)Click on Edit Connections on the bottom
3)Go to the Mobile Broad Band Tab
4)Click on Add connections and give the necessary details 
5)Select the provider as MTS Mblaze and then add
6)Give any connection name

Then on the Mobile Broad Band settings Add the following

Number - #777
username -
password - mts

Save it and then connect it after you plugged in the Data Card


No comments:

Post a Comment